Page 4 of 4
Re: C-GSEM
Posted: Mon Apr 07, 2025 4:32 pm
by Maurits van Rooy
Next day the new pitot/ static lines was installed with co ax cables hooked up.
Connectors and pitot / static lines connected to the displays with ample service loop to do so.
First power up of the panel in the aircraft. Testing off everything started.
Sent from my iPhone using Tapatalk
Re: C-GSEM
Posted: Mon Apr 07, 2025 4:35 pm
by Maurits van Rooy
DX1 engine gauges versus the G3x style gauges for relative size comparison.
Sent from my iPhone using Tapatalk
Re: C-GSEM
Posted: Mon Apr 07, 2025 4:37 pm
by Maurits van Rooy
AC system integrated and tested and working great!
Sent from my iPhone using Tapatalk
Re: C-GSEM
Posted: Mon Apr 07, 2025 4:41 pm
by Maurits van Rooy
Detail of the removable headliner and overhead console harness where we ran the temperature sensor back to the evaporator inlets.
Sent from my iPhone using Tapatalk
Re: C-GSEM
Posted: Mon Apr 07, 2025 4:50 pm
by Maurits van Rooy
April 6th and we are getting ready to taxi out to the compass swing area to calibrate the magnetometers.
Nose gear over centre bushings being replaced - why the no green nose gear light.
Note the hoist from the hanger roof to jack the nose so we can swing the nose gear before taxiing out.
First start of engine and taxiing out was great - GTN’s got their satellite signals and G3x was very happy after the magnetometers were calibrated as well.
Sent from my iPhone using Tapatalk
Re: C-GSEM
Posted: Sat Apr 12, 2025 1:34 am
by Maurits van Rooy
First flight today and everything went very well!
Sent from my iPhone using Tapatalk
